Deploying the Stack

Note

Allow 45 minutes to complete this task. 5 minutes for the stack and 40 minutes for the initial (ALL_TARGETS) data load.

With the graph installed we can now start the Fragalysis Stack and its Data Loader.

Deploy Fragalysis by launching the Fragslysis Stack template.

../../_images/demo-job-templates-fragalysis-stack.png

As the stack initialisation is a little more deterministic (and short) the job waits for the stack to become ready before finishing. When this job finishes you know the stack is “up and running”.

You can’t use the stack without any target data so you now need to run the Data Loader.

Deploy the loader by launching the Fragslysis Stack Data Loader template (see below).

../../_images/demo-job-templates-fragalysis-stack-data-loader.png

This job will also wait for the loader to complete. As we’re running a typical ALL_TARGETS load this will take around 40 minutes. The job will time-out after an hour.

Once complete you should be able to navigate to the application by navigating to the URL you used for stack_hostname.